Other Controls

PolAIR™ 400HC Unit

The PolAIR™ 400HC is designed to control and regulate the PolAIR™ High Pressure Fog System by temperature and humidity. The 400HC can be configured for single or two stage / zone operation. Specifically designed for the PolAIR™ System, the 400HC includes the motor starter, motor thermal overloads, inputs for 2 temperature and 2 humidity sensors, single or two stage / zone cooling and humidification capabilities.

PolAIR™ Sequence Panel

The PolAIR Sequence Panel includes automatic relay contacts for interfacing control devices like the PolAIR 400TC Time Controller and other activation devices such as computerized control systems or in house plant DCS networks. The Sequence Panel includes real-time monitoring and alarming of the motor thermal overloads, sequencing of the inlet water supply and pump drain solenoid. Pump run time is maintained in the sequence panel for up to 32,000 hours and an on board system maintenance meter is provided. There are also built in delays for the inlet water supply to assure that the pump starts with a full head of water. It just really can't get any easier!

Ventra™

The Ventra family of products provides environmental monitoring and control for hog, poultry and other types of operations. Ventra controllers can be set up to meet the unique needs of hog or poultry operations by simply selecting either "Hog" or "Poultry" in the software menu. Modern environmental controllers provide a consistent climate for your animals resulting in better feed efficiency, better growth and lower mortality.

This is achieved through careful monitoring of temperature, air speed, humidity, static pressure, feed use and water use. All of these "inputs" are used to determine when to turn fans on and off, when to open and close the air inlets, when to turn on tunnel ventilation and much more. Using the controller’s keypad, you simply input operating parameters for your devices, desired building temperature (which can be adjusted automatically over time), and conditional decisions such as at what humidity level should fogging/misting be disabled. Rest assured, if something goes wrong the Ventra activates an alarm output relay which can be used to notify you of critical errors in water, feed, power, temperature, air pressure, RH and data communication.

Climatrac 400

A low-cost ventilation control that can run various device configurations, including some for your evaporative cooling system. It also features high-humidity cutoff for evaporative cooling and manual overrides, should it ever be needed.

Accessories

ThermoTRAC™ Model 7000 Backup Control

A rugged, independent control that automatically takes over in case of a primary system failure. Loaded with features and capabilities that enable it to perform all critical equipment operations to maintain a proper house environment. May also be used as a contactor panel or as an economical stand-alone control.

Vari-Speed Station

Up to 5 stations can be added to the GainTRAC™ 3200 and 1600 controls. Each station provides two variable speed output channels. Fans may be run on time cycles or ramped up to maximum speed as temperature rises. Equipped with manual override.

Static Pressure Sensor

Compares inside and outside air pressure and controls position of inlets to maintain a programmed static pressure setting. If sensor readings exceed acceptable limits, the GainTRAC™ control will generate an alarm condition.

DeadBolt™ Lightning/Surge Arrestor

Effectively protects equipment from lightning damage. Available in 3 models for power circuits, telephone lines and data lines.